Back

The cost of universality

"A comparative study of the overhead of state distillation and code switching with color codes"

Published by Michael E. Beverland, Aleksander Kubica, Krysta M. Svore, 6th January 2021

arXiv:2101.02211
Error correction
The cost of universality

The authors of this work provides a comparative study of the overhead of state distillation and code-switching, and enables a deeper understanding of these two approaches to fault-tolerant universal quantum computation (FTQC). FTQC requires a gate set that involves at least one non-Clifford gate, which is typically generated through such protocols. State distillation relies on first producing many noisy encoded copies of a T state (magic state) and then processing them using Clifford operations to output a high fidelity encoded version of the state. The high-fidelity T state can be then used to implement the non-Clifford T gate. State generation and distillation is still a resource intensive process, despite significant recent improvements. A compelling alternative is ‘code-switching’, for example via gauge fixing to a 3D topological code. However, moving to 3D architectures is experimentally difficult, even if it significantly reduces the overhead compared to state distillation.

This work estimates the resources needed to prepare high-fidelity T states encoded in the 2D color code. This is accomplished via either state distillation or code-switching assuming that both approaches are implemented using noisy quantum-local operations in 3D. In particular, these two approaches were compared by simulating noisy circuits built from single-qubit state preparations, unitaries and measurements, and two-qubit unitaries between nearby qubits.

It is reported that the circuit noise threshold achieved for the code-switching implementation in this work is the highest presented to date and is equivalent to the circuit-noise threshold for the state distillation scheme with the 2D color code.

A direct way to switch between the 2D color code and the 3D subsystem color code is explored. The method exploits a particular gauge-fixing of the 3D subsystem color code for which the code state admits a local tensor product structure in the bulk and can therefore be prepared in constant time. The restriction decoder was adapted for the 3D color code with a boundary and produced a high error threshold. However, the failure probability of implementing the T gate with code-switching and the estimated T gate threshold is found to be lower than the one calculated for the state distillation.

The results suggest that code-switching does not offer substantial savings over state distillation in terms of both space overhead, i.e., the number of physical qubits required, and space-time overhead (the space overhead multiplied by the number of physical time units required) for most circuit noise error rates. Code switching holds a lot of promise, but is dependent on the clever design of codes that have transversal implementations of non-Clifford gates, and such a protocol is at the moment inferior to the state distillation. There exist other protocols that rival state distillation, like the pieceable fault-tolerant implementation of the CCZ gate, which in general shows the importance of having a protocol for non-Clifford gate implementation with a relatively small number of qubits and operations.